And follow the link to: https://www.rsgbcc.org/hf/rules/2022/r80m_ft4.shtml Note nonstandard frequency (at least on 40M) and 90-minute contest time window. Unfortunately, that’s mid afternoon in

Is your time correct? Check http://time.is Mike W9MDB

Second line in section 5 of the WSJT-X User Guide: Be sure your transceiver is set to USB (or USB Data) mode. 73 -Jim NU0C "fritz1000 via groups.io" <fritz1000@...> wrote:

I just upgraded to a new ham shack computer. I have WSJT-X installed and wanting to use FT8. I can hear the FT8 signals from my radio and see them on waterfall. I have the radio tab set up and the

Thanks, Alan. Yes, it seems an 8 second delay can still result in a successful decode on the RX end. But I was hoping to gain a bit more insight. Can it be done at 9 seconds? Ten seconds? Where

Windows 10 pro operating system Wsjtx was working fine with ft-991a, expanded work area, new radio and new larger desk so ask equipment disconnected, cleaned and cabling strighted out. After putting

look at https://www.contestcalendar.com/weeklycont.php Dave Garber VE3WEJ / VE3IE

Ed If you're asking about the RSGB FT4 Contest, its actually on Monday afternoon 1900-2030Z. You can find the rules at https://www.rsgbcc.org/hf/rules/2022/r80m_ft4.shtml I can supply more info if

JT-AlertX is the answer: http://hamapps.com/ I've been using it for years, works like a charm :-) Vy 73, Alex - DH2ID

Can you give me a link to the contest rules? I've googled it and looked various places and can't find them. Ed W7EDP

check udp settings Dave Garber VE3WEJ / VE3IE phredyh@...> wrote:

dont put auto sequence on, or call 1st, then you should be able to selevt who you answer... Dave Garber VE3WEJ / VE3IE

make sure 4-usb audio... exists in device manager it may have been reassigned by an update or taken by MS Edge... are you running a signalink or similar on the 480, or does it have built in usb. I

Hamspots.net is bit better/faster if you're trying to track this. Mike W9MDB

pskreporter hits come from other stations successfully decoding your transmission. So you have already determined your answer. 73 de w6akb

How late can I start transmitting an FT8 signal in the 15-second cycle before it becomes a waste of time? I can score PSKReporter hits by starting my TX6 CQ message as late as 8 seconds into a

I was attempting to activate HRD but was unsuccessful. I have the same situation with WSJTX - no transmission, although everything else seems to be OK.. I'm unable to transmit in WSJTX. In the

It looks like the 991A should be able to use DT-G (DT Gain) to adjust the tx audio level instead of using the Windows controls.It's on the Multi-knob menu Can you try that? It's a bit better to do

Duo setup for OmniRig should the the TS-480 -- nothing fancy -- 8N1 and no flow control. Mike W9MDB

OK, I figured it out. The TX audio setting for the radio sound card was reset to 100% by the update. In my situation, I need it around 50%. Apparently, the ALC was locking it down completely.