dont put auto sequence on, or call 1st, then you should be able to selevt who you answer... Dave Garber VE3WEJ / VE3IE

make sure 4-usb audio... exists in device manager it may have been reassigned by an update or taken by MS Edge... are you running a signalink or similar on the 480, or does it have built in usb. I

Hamspots.net is bit better/faster if you're trying to track this. Mike W9MDB

pskreporter hits come from other stations successfully decoding your transmission. So you have already determined your answer. 73 de w6akb

How late can I start transmitting an FT8 signal in the 15-second cycle before it becomes a waste of time? I can score PSKReporter hits by starting my TX6 CQ message as late as 8 seconds into a

I was attempting to activate HRD but was unsuccessful. I have the same situation with WSJTX - no transmission, although everything else seems to be OK.. I'm unable to transmit in WSJTX. In the

It looks like the 991A should be able to use DT-G (DT Gain) to adjust the tx audio level instead of using the Windows controls.It's on the Multi-knob menu Can you try that? It's a bit better to do

Duo setup for OmniRig should the the TS-480 -- nothing fancy -- 8N1 and no flow control. Mike W9MDB

OK, I figured it out. The TX audio setting for the radio sound card was reset to 100% by the update. In my situation, I need it around 50%. Apparently, the ALC was locking it down completely.

Currently using omnirig but having problems adding, changing radios. Would be interested in seeing Duo set up. Thanks K2NNJ

On some previous updates it has been necessary to uninstall audio devices and reinstall them.  Been quite a while since that has happened. Sounds like that could be the case. Mike W9MDB

Watch out for the newest Windows 11 update. I can't get sound to my 991A, despite fixing the reversion to default audio, etc. CAT control works, receive audio works, I can get audio to speakers, but

If you are on Windows JTAlert can filter by continent and you can add unwanted calls to block. Mike W9MDB

I am using an FDM-DUO with DUO ART amp. I run WSJT-X, JTAlert, Log4OM and SW2 all at the same time. I have screenshots of most of the configurations and can send them if you wish. In WSJT-X I am using

Ham spirit... Pietro I2OIM

Hi.. Just wondering if it's possible (or as a feature request) to be able to filter call signs by location (and/or by specifying a single call sign to be blocked) ? When trying to work DX (esp for a

I don't see anywhere that this was suggested. Open WSJT-X. Set operation to 40m. Go to the WSJT-X "MODE" drop down menu. Verify that FT8 has a check next to it.

William Smith and Reino Talarmo are correct, plus setting the account you use on a daily basis to a standard account CAN mitigate many types of infections as long as you don't type in your admin

THANKS DENNIS . I JUST CLEARED MY FILE FROM THE LAST CONTEST. GONNA GIVE IT  TRY. -- *73'S DAVE NU4N*

TNX FOR THE REPLY. GONNA GIVE IT A TRY. 73'S DAVE -- *73'S DAVE NU4N*