New hamlib for installation directions #1 Shut down WSJTX/JTDX #2 Download either the 32-bit or 64-bit DLL matching the 32/64-bit version of WSJTX/JTDX -- hopefully your browser doesn't block it but

Click on Help, then click on Local User Guide and search for a7. 73 Stan KM4HQE

I noted that A7 is not in Table 1.  This might have been a recent addition to FT4/FT8. It's in Table 2. A7 indicates that all 3 tokens here were hypothesized and the resulting decode had high

Yes, I carefully set the mic adjustment to show the flickering 5th bar. I had a look at wsjtx_syslog.log and set the following errors which appear to be logged once a minute. [RIGCTRL][2022-06-18

Can you be a little more specific as my users guide has not search function and I have looked every place I can think of and can not find it tnx AH0U

Search the User Guide for a7. Its fully explained there. Charlie DL3WDG

Read them but it does not state what the a7 means other than additional messages tnx AH0U

I did that first thing but it does not state what the a7 means other than other message

Done that and all it says is additional message... I want to know what the a7 means. tnx, bc

Are you showing the standard Elecraft 4 bars with 5th flickering under ALC?? Neil, KN3ILZ

See release notes on version 2.6.0 rc1

You're using the Release Candidate version, which is a BETA test.  All changes are listed in the RELEASE NOTES on the WSJT-X site.  There's a shortcut built into the HELP menu under RELEASE

Open the Help file and search for "a7". Mike W9MDB

William Smith and Dave Garber, Thanks to both of you for your help. I usually can solve most technical issues since it's what I did for a living over 35 years but this has me stumped. Here are

Where can I find an explanation of what this means? Tnx AH0U

Sorry, but F&H - "SHOULD BE" USED ONLY ON non-std freqs; however, we just had a couple of dxpeditions that DID use Std. Freqs & threw a whole box of wrenches into the works! Ironically, they gave a

I know this can be a deeper subject and not exactly about WSJT-X but the various studies done seem to suggest that you use a 43 mix for HF baluns and 31 mix for HF chokes. See Balun Design's Web

The F250 is the SIZE of the Torroid.  The -31 is the mix. -31 is best for HF -43 is best for VHF can actually get them thru Amazon (probably easiest) Gwen KI5PXQ

Jim, Reino, and Gilbert, Thank you for the replies. They all are helpful. As a new General I know I have a lot to learn. I don't have any F-31 toroids but I added several of the clip on ferrites

I didn’t use any interface at all with my 991A!! Just a usb cable! Worked great using wsjt-x