Mark, How do you have your TS-450 wired up for CAT? Using the Kenwood IF-232? Have you tried it with a different radio control program other than WSJT-X? Good Luck, Eric (W1EL)

Hi Bill, Its the CAT control that doesnt work, Im geeting cannot retrieve frequency from radio, current rig control on flrig setting doesnt move the frequency on the TS450 device/radio. What I did

Yes, have the same #4 wire connecting the house ground with the station ground. Both antenna masts also bonded. Learned that from this website!!

Good advice!!

Brew a pot of coffee and give this a read: http://audiosystemsgroup.com/RFI-Ham.pdf 73 -Jim NU0C "Mark Gottlieb" <kk2l@...> wrote:

Yes I did the double click to put him in the TX window. For some reason the RX station or any station I try does not answer which is strange. Dave KC3AM

And is your ground rod bonded to the house ground too? Mike W9MDB

It depends on how susceptible the USB cable is to RFI. Mike W9MDB

I should have come back to the group sooner. I didn't get an e-mail that my original post was answered. Anyway...bingo! Yes, when I reduce power, (down to 45 watts) even on the upper bands, the

Mark, I’m new to WSJTx but for ham radio in general, I have 6 copper ground rods, 6 feet long bonded with #4 gauge wire and many would consider that inadequate grounding. One rod not enough. Gary

Question. I’m using an old Kenwood TS 850s, and thinking of getting a second radio. I am considering an ICOM 7300, but noticed how cheap IC 718’s are at the present. Any comments good or bad using

One more thing...just to be clear, I am experiencing this issue on my portable CHAMELEON MPAS 2.0 which only has a radial coming from the antenna and my universally grounded (copper rod) antenna in my

Does the problem go away if you reduce the output power to near zero and/or transmit into a dummy load? If so, it's almost certainly RFI. 73, Willie N1JBJ

I just got back to the group. My shack is grounded to a copper rod buried in my garden. All radios, amps, tuners etc are wired to the same copper rod. 73 Mark KK2L

Good Afternoon All, I am having this same problem but only from 18mhz on up. On 14mhz down, the rig (IC7100) interfaces normally and well with WSJT-x and FLRIG. Icom radios do have a one USB cable,

Hi to all. I developing SDR software for LimeSDR-USB (2ch RX 0.1-3.8GHz) and I'm stuck with MAP65 network protocol. So far I managed to form UDP packets and send them to MAP65, they are displayed

What does "just not perfect" mean? Mike W9MDB

What order do you start your software? Do you have Log4OM starting WSJTX? Try starting WSJTX before Log4OM. Mike W9MDB

Hi, Thank you all for the replies and I must make an apology Bill I was incorrect in my statement that it slowed down the programme as I have no evidence of this. As for the uploading of the adif file

Hi Bill & Mike, I have re-visited all radio / software settings, and changed speed to 19,200 & poll: 100ms , No Change I also tried latest version of omnirig, 1.20 , No Change Going to try installing