Hi Bill The timing is curious isn't it? Always starts receiving at the zero second of the minute and stops at seven seconds. 73 Ian

Hi Ian, I doubt Edge is using UDP on any port so that is not an issue, TCP and UDP are separate. The only requirement on port numbers is that whatever you set in the MAP65 settings for the port to

Hi Bill I moved the UDP port in Linrad back to 50004 instead of taking Linrads assignment and get the same result. also did a restart same result. This windows 10 PC is brand new and has no other

Also windows allows you to disable system sound access to any audio device incl default. vk4tux

Hi Bill Thank you for the reply Linrad tells me to use 50024 which is the only one that works. What other process might use 50024 ? How would I find it ? 73 Ian

OM, is it possible that another process is also listening for UDP datagrams on port 50004? As that is in the ephemeral port number range on MS Windows it is possible it has been granted to another

Correct, Bill. So, what do you suggest that will correctly configure the xmit audio? I actually was trying to keep it simple by not going thru all the other options, which I've tried;

My installation of MAP65 3.0 is receiving for only 7 seconds at the start of each minute and the the receiving stops. I am using Linrad to send UDP packets. I checked with Wireshark and the UDP

Hi Eric, Actually, of course, it's the opposite. Bill has been working too hard answering questions here. You need to DECREASE the "N Avg" spin box value to SPEED UP the scroll speed so there will be

OM, you should not be using "Default" audio devices as that is where system sounds and output from other applications with no soundcard selection will go. 73 Bill G4WJS.

Hi Mike & Thomas, the correct location on MS Windows is "%LocalAppData%\WSJT-X" as noted in the WSJT-X User Guide here:

Hi Thomas, In Windows File Explorer substitute your username for "Owner" in the string below. C:\Users\Owner\AppData\Local\WSJT-X -- Mike - KM2B

Hi Nico, You may mix what split means is wsjt-x. It does not mean that you are using different reception and transmission frequencies. Actually that setting is totally independent of that “split

So, WSJTX has been just fine until just recently.  The current version receives fine, decodes incoming signals fine. First time launch, the CQ transmits fine.  Any subsequent transmission keys the

Bill, Thanks! I had increased the font size and that made it go away. Now I know! 73, W1EL

of course that should have been decrease the value to speed up the waterfall scrolling speed. 73 Bill G4WJS.

Hi Eric, increase the "N Avg" spin box value to slow down the scroll speed and leave room for the annotations. 73 Bill G4WJS.

Greetings, I have somehow made the white text at the left side of the wide graph that identifies the time slot and band disappear. I’ve searched the manual and the archive of this list and come

fixed the problem! In the setup menu, the Split Operation was set to "None" (since I do not want to operate in split for digital modes). Set this to the option "Rig" solved the issue with the ooB en

Yes, I use Omni-rig with Log4om. I think that I have to look deeper into Omni-rig. Kari has a valid point to check for possible Omnig-rig support. Thanks, 73, Nico PA3ADU