Hi Bob, so I can see what is happening please run the following test. Put the attached file into your WSJT-X configuration files directory (on MS Windows that is the same as the log files directory

Hi Ian, yes that may be a clue, but I have no idea what is happening. Perhaps a conversation with one of the other EME ops using Linrad as a source for MAP65 may help discover

Hi Amos, 1) no WSJT-X does not currently understand I/Q data, you will get some decodes by selection one of the I or Q channels but that is sub-optimal and you should use a base band audio stream of

Hi Jeremy, currently WSJT-X resets the CAT connection when you change settings and exit the settings dialog. We recommend setting up a separate configuration for FT8 DXpedition Hound mode

I have recently discovered that WSJT-X v.2.5.0 does accept the DAX IQ RX audio channels of my Flex 6600 instead of the DAX Audio Rx I did use for years. 1. Does WSJT-X take advantage of the additional

I'm running version 2.5.0 on Intel Mac, FT8 F/H as a hound. I opened the preferences window and updated the IP address to send my log over to MacLoggerDX. When I clicked OK to save the preferences,

hi all, upgraded from version 24 to version 25 and have noticed the new version doesnt put my 9100 into data mode, it stays in usb (voice) mode I've switch back to version 24 which like all the others

Hi Bill The timing is curious isn't it? Always starts receiving at the zero second of the minute and stops at seven seconds. 73 Ian

Hi Ian, I doubt Edge is using UDP on any port so that is not an issue, TCP and UDP are separate. The only requirement on port numbers is that whatever you set in the MAP65 settings for the port to

Hi Bill I moved the UDP port in Linrad back to 50004 instead of taking Linrads assignment and get the same result. also did a restart same result. This windows 10 PC is brand new and has no other

Also windows allows you to disable system sound access to any audio device incl default. vk4tux

Hi Bill Thank you for the reply Linrad tells me to use 50024 which is the only one that works. What other process might use 50024 ? How would I find it ? 73 Ian

OM, is it possible that another process is also listening for UDP datagrams on port 50004? As that is in the ephemeral port number range on MS Windows it is possible it has been granted to another

Correct, Bill. So, what do you suggest that will correctly configure the xmit audio? I actually was trying to keep it simple by not going thru all the other options, which I've tried;

My installation of MAP65 3.0 is receiving for only 7 seconds at the start of each minute and the the receiving stops. I am using Linrad to send UDP packets. I checked with Wireshark and the UDP

Hi Eric, Actually, of course, it's the opposite. Bill has been working too hard answering questions here. You need to DECREASE the "N Avg" spin box value to SPEED UP the scroll speed so there will be

OM, you should not be using "Default" audio devices as that is where system sounds and output from other applications with no soundcard selection will go. 73 Bill G4WJS.

Hi Mike & Thomas, the correct location on MS Windows is "%LocalAppData%\WSJT-X" as noted in the WSJT-X User Guide here:

Hi Thomas, In Windows File Explorer substitute your username for "Owner" in the string below. C:\Users\Owner\AppData\Local\WSJT-X -- Mike - KM2B

Hi Nico, You may mix what split means is wsjt-x. It does not mean that you are using different reception and transmission frequencies. Actually that setting is totally independent of that “split