Every now and then WSJT-X throws a Subprocess Error while WSPR RX Band hopping on a Rpi 3B+ (Buster). If I click "OK" WSJT-X crashes. If I leave the Error window untouched, WSJT-X continues to

With me, I'm noticing just lately that the TX frequency logged is different than the dial frequency no matter what my VFO uses are (settings are). Is that correct? Thanks, Kevin, K7KSH On

I'm with you on this Bob. Much ado about very little. Goodness, we can't change the mode from USB-D or DATA-U or whatever to RTTY? As far as I can tell, if I use Winwarbler, FLdigi, DM780 or other

Lots of RFI issues on the forum, one solution never mentioned is loose PL259 connector. I had that happen to me, if only finger tight I find they tend to loosen themselves up over time. I use a small

I did. Another file?

Did you rename the rumlog to wsjtx_log.adi. and what about the other log file... I forget the name of it. Not sure which is rescanned.

I've read it several times. it just isn't behaving as the manual says.

Is Menu 030 the same on both rigs? Looks like they should behave the same. You can test this yourself -- adjust com port and baud rate to suit. See if the antenna selection follows the band

As Bill indicated, no special drivers installed. Here are my settings in WSJT-X for the 991A, hope it helps:

Thanks Doug I copied (or perhaps moved and renamed by mistake) the rumlog adi file to the same directory as the original wsjtx_log.adi and renamed the old one. The old one had all the qsos from this

Cliff, The frequency that’s logged is the TX frequency PLUS the audio offset, so the actual frequency of transmission NOT the dial frequency. 73 Phil GM3ZZA Sent from Mail for Windows

I'd like to see the default frequencies displayed in a distinct font in the band drop-down list, perhaps bold. This would help to identify the defaults when one has added frequencies for DXpeditions,

Thanks so much for the clarification, Sam. Since that is normal I'm changing the settings back to split operation. I'm wondering which frequency will be saved to the log. I'll find that out in short

For roughly the last year I have been only on FT8. It has only been in the last few months that I put up an end fed half wave, that is when the antenna selection problem started. So I don't see how

To be a little more descriptive.... In order to avoid harmonics and bandwidth limitations Rig Split and Fake It both adjust the transmit frequency so that your audio is maintained in the 1500-2000Hz

Read up on Menu 031 for the Band/Stack option and elsewhere in the manual about band stack. I think you probably want the Band option. You should be able to set up the band and press the band button

Alright, problem solved. Big thanks to Mike for the debugging. Turns out it was a failure between the PC and the id10t interface, aka dying mouse. Clicked on the poor fellas left ear one too many

I have problems with WSJT-X and the FTdx-3000 rig in that my antennas (two) don't get selected as the bands change. Someone involved with HamLab was helping by sending me a file to include in WSJT-X

Hi Cliff, That is normal operation when using split = rig. It is shifting the frequency so that your TX audio is in the middle of the band pass. FYI, you do not have to press the "VFOA=VFOB" The

Bill, Thank you. Exactly the hint I needed and WSJT-X is running flawlessly. Now to figure out the Icom-7300 issue. Best, Ted K8UKE