Hi Dick, the WSJT-X User Guide has the answer to that. https://physics.princeton.edu/pulsar/k1jt/wsjtx-doc/wsjtx-main-2.4.0.html#_ap_decoding 73 Bill G4WJS.

In following window, what is the meaning of the "a1" and the "?" which is shown on some lines on the right side? Thanks and 73, Dick,, KD4S

Thanks Bill. I will try that. Kind regards - Terry

On 01/09/2021 15:01, Gene Horr wrote: Gene, it was only a suggestion, CI-V Transceive Mode causes the rig to emit unsolicited CAT traffic which can collide with commands from

On Tue, Aug 31, 2021 at 10:03 PM, Gene Horr wrote: 7300 when in Rig split mode only. No problem all other modes. V2.4.0 When changing the TX offset frequency enough to require a change in the split

> make sure you have "CI-V Transceive Mode" disabled on your IC-7300 Makes no difference. Out of curiosity how would this effect the commands WSJT-X is sending out and how would this make the rig

For general HF work I choose to call CQ in the time slot with the strongest signals. There is a benefit to having all the RX signals near the same level without one or more big signals in your RX. Bob

Thanks

Hi Gene, make sure you have "CI-V Transceive Mode" disabled on your IC-7300. 73 Bill G4WJS.

7300 when in Rig split mode only. No problem all other modes. V2.4.0 When changing the TX offset frequency enough to require a change in the split frequency occasionally the base frequency will

There will always be a frequency change, as the frequencies of the FT4 'areas' are different from the FT8 areas. As far as why its missing, have you tied doing a Frequency List reset?

Hi Jack, FT8 and FT4 use different transmit periods so are not compatible, they are used in different frequency sub-bands. The WSJT-X "Settings->Frequencies->Working Frequencies" table defines the

When switching from FT8 to FT4 (under the Mode pulldown), I get a different set of frequencies and there is no choice for 14.080. In fact there is no 20M choice at all. What am I doing wrong? Jack

Bill - Thanks for the input. The sound card has analog audio out (of course) but I don't know how much, if any amplification, it has. I modified my settings by decreasing the KX3 mic gain to 10, and

Hi Terry, you can diagnose which end the problem lies by using the test application message_aggregator that ships with WSJT-X. Run that with two instances of WSJT-X and use it to initiate QSOs to see

Apologies if this has been asked before. I have one copy open for my IC-9700 on VHF/UHF and the other for HF on my IC-7300. I use the call roster on GridTracker and when I double click on a station it

Bill, Yes - I knew about the release of WSJT-X V2.5.0-rc5 but as I'm not very good with computers thought that I'd leave it to much better beta testers first. I will continue to run the old Map65 on

Never thought about that after the latest update, I changed the power management to off, thanks!

Is it possible you (un)plugged a USB device, (dis)connected a Remote Desktop connection, (had Windows automatically and without warning) do a Windows Update, or something else? It might be useful to

Ryan Is there a memory leakage somewhere along the line. Keep an eye on the amount of memory WSJT-X is using. If it is slowly climbing up, sooner or later it will crash. How long depends on what