You do realize that Hamlib has been changed and upgraded since v2.0.1 was released in 2019, right? Also, you haven't said anything about what OS, rig, or interface you're

Thanks for the replies, all. I was operating FT8 on the wsjt-x standard frequency, 14.074, and I'm aware that 14.0715 is a standard PSK slot (indeed there was one PSK station in the mix). I often

Hi Randy, Thanks for the reply. 73, Sam W2JDB

That makes more sense Bill. Well, I will uninstall Hamlib and re-install it, then uninstall WSJTX and fall back to a previous version as it WAS running in previous months. Hopefully I can get back to

Hi Dave, if you are seeing Zones then you probably have the Zone highlighting options at higher priority than others. That means until you have worked those the next priority highlight will not be

Hi OM (still no name?), it helped but not in a positive way. It looks like the gdb backtrace (bt) command is not showing the current stack frames that would give some clues to what routine was

Oh, hate to reply to my own message, but the cool thing is that a program created for node-red on one platform (Linux/Raspbian/Mac/etc) can be easily copied to another platform. At most, if you

It runs in the node-red environment only. For most people, they have it running on a Raspberry Pi. They set it up to run automatically on restarts. Typically, there is a timer or two to set off the

Windows 10 WSJT-X v 2.4.0 Icom IC7300 I am new to WSJT-X and I'm still learning many of the configuration options. So far I have managed to get WSJT-X to decode and transmit, although I'm still

But I don't think I've ever installed or used QT??

I'm seeing a lot of noise on your waterfall. I've seen problems with some computers having really bad internal noise. Let's talk signal levels.... Speaker level is in the region of 1V to 100V Pro

Derek, As Bill has said, if it works satisfactorily then do not worry. Different devices do not always match. It may be that the best driver is not loaded, maybe just Windows generic USB sound

I hand point the antenna and the cable is short. Hearing the echo in CW is an art, but hearing an echo as programmed into WSJT ( 2 s repeated transmissions over several minutes) should be simpler.

Did a test with an old version v2.0.1, yes old. CAT works perfectly to my Rig and PA ! When I change band in WSJT-x the band is also changed on the Rig and PA ! 73/Bengt, SM6MUY

No..I didn't detect a bug necessarily...I just put a check on the one strcpy routine in flrig.c to spit out a debug error message and avoid the strcpy when the argument is null. But it appears from

It’s still supposed to be. I’ve had the occasional PSK31 QSO on this frequency. More interesting than the wham bam thank you ma’am FT8 QSO’s. That said I had a ten second CW QSO the other day-

Hi Derek, I have the same exact situation. Just little back ground: I was using a SIIG USB/Audio adapter (I have no clue which audio chip it implements). About two Windows updates

"So 0dB is OK?" In my case yes. But I want to be clear. In my internal sound card (Motherboard), the mic input has a gain control AND a level control. Its the gain control that makes the difference in

Did the "Info Threads" data help anything? My understanding at this point (from the replies here) is that Mike has detected a bug in Hamlib and will fix this in the next release -- but when is that

While operating FT8 on 20m recently, I've noticed activity below the tuned frequency. Timing and appearance on the waterfall make it look like someone was operating FT8 on LSB instead of USB. There