Bill My H/V Yagi antenna does have 2 separate H and V outputs which are separated by quarter lambda /90 degrees phase shift. It is possible combine it to one output with Circular Polarization. Is

Bill Please explain what do you mean by 4 channel audio device feeding an interleaved pair of I/Q channels. My Flex 6600 radio can deliver 4 channels of I/Q data out of 2 separate ADC connected to 2

Amos, as discussed previously MAP65 when used for polarization diversity requires a pair of synchronized I/Q channels which must be interleaved, that is not possible if your starting point is two

One other interesting note that I believe removes RFI from the equation - I can induce the issue by changing frequencies in WSJT-X. Let's say I am on 20 meter, if I select 30 meter from the drop down,

Reino, Thank you for you testing results. My walking has stopped after disabling the 'Allow Tx frequency changes while transmitting' as suggested by Bill. I will try changing the baud rate to the rig

Sorry, did not notice Linux,follow Bill's instructions. 73, N0AN Hasan

Hi Steve, upgrading from one obsolete and unsupported version of MS Windows to another seems unwise to me, like it or not your best option is to upgrade to Windows 10. 73 Bill G4WJS.

Joe I am preparing to work EME using Q65 on 2m: I have a CROSS H/V long Yagi. I have a Flex 6600 Radio which can support 2 antennas In parallel 1. To enable the use of Q65, do I need a 2 channel

Hi Ron, the relationship is not straightforward. Nominally audio starts 500 mS after the start of the period for FT8 mode. PTT is commanded at the start of the period but if the CAT control is able

Hi Les, what you have logged in your main station log file has no bearing on worked before highlighting by WSJT-X, that is determined by the WSJT-X log file wsjtx_log.adi in the WSJT-X log files

Hi Carl, instructions for installing and uninstalling Debian packages are included in the WSJT-X User Guide:

TU, Hasan ! I'll try today also ! 73 Karl Am 06.06.21, 04:34 schrieb Hasan Schiers N0AN <hbasri.schiers6@...>:

I just noticed the OS you're using. You should still be able to install to a designated directory since you're building the RC version locally. Neil, KN3ILZ

You can install the RC version to a separate directory, it will use the same log and .INI file as the current GA version. However, its an open BETA. If you use it you are requested

Just install the previous version over the top of the new one. No need to Uninstaller. 73, N0AN Hasan

Hello Gregory! So far everything looks good. What settings do you have in the PTT tab for flrig? In my case I found having PTT via CAT enabled and unchecking the boxes for RTS +12v and DTR +12v

Hi All, I'm using WSJT-X with JTAlert and Logger 32. All qso's are logged and, via SOCAT, into Logger 32 also. Each program is at the latest rev. I've been through the Help File several times but

Hi Mark and Bill, I tried to repeat that functionality, but could not persuade my FTdx3000 to behave as Mark described. I have somewhat different settings: bit rate 19200 and all Cat control

Hi, I had the following issue on SAT QO-100 in Q65: only 210604_184530 decodes CQ... the other enclosed files do not decode. Other stations work very well, but only this one does not ! What can that

Hi, If I install the new v2.5.0-rc1 and (in case) it does not run, how can I go back to 2.4.0 ?? have: raspi 4B; raspbios buster 2021 Thanks for answer ! 73, Karl OE3JAG