I see that many of the VHF folks on FT8 or MSK144 are able to report locator strings longer than 6 characters to PSK Reporter. But WSJT-x doesn't seem to allow anything beyond 6 characters. I would

Never had a problem. WSJT 2.4.0-rc4, Windows 10 20H2, microHAM MK II/MK III (external USB sound card), Elecraft K3. Using PTT=RTS on a separate COM port. I'd be more disposed to an error in your

Hi All ! I use WSJT since February 2014, with no problem. Actual set-up: FT-847 WSJTX 2.3.1 via JT-Alert to DXLab Commander and DXKeeper; Windows 10 64bit. FT-847 does not accept frequency changes via

In my case VAC. dod On 4/24/2021 9:50 AM, Don Roden wrote:

USB

What interface ?

This has been going on for some time now. I have learned to do a test tx first. Bob - wd6dod On 4/24/2021 5:23 AM, W4ARK wrote:

I've been reading though a paper on QRA codes and QRA64 design by Nico Palermo and can just about make sense of the encoding process, but there's one aspect I can't get the rationale behind - it just

I was surprised last night to have the red Q65 sync line disappear from the Wide Graph on both computers and receivers at the same time! Then it would re-appear without warning. I can't figure out why

I continue to periodically see my own callsign in the band activity window. As I said before - it happens after the watchdog terminates transmit - and the timestamp corresponds to when it was

-- Jim KM6GUO

Yes, I agree.... I Have the same issue. In the meantime I do cope with that.... Am 24.04.21, 14:43 schrieb W4ARK <cerritas@...>:

After opening WSJT-X, or after changing bands, WSJT-x does not provide audio drive to the transceiver for the first transmit cycle. If you select Halt Tx and then Enable it will drive the transmitter

I would love an implementation of this. I'm running wsjtx on a pi mobile and I have a gps input. Could XASTIR pass grid to wsjtx?

Bill, I am experiencing the issue and able to repeat it. I was able to capture the log and will be sending it to you. I am using a RigPi Pi4 using Hamlib Net with WSJT-X to access the rig control. I

Bill- Since this is a receive only situation, I did not think to click ENABLE TX. SO I did, still does not work. "DAY, NIGHT etc" still not showing bottom row. I also run WSPR on Ubuntu 18.04, it's

Yes, It works for me BUT, you need to let it do a single 2 minute cycle before you tick the schedule box or it can close when it switches bands Peter M0PWX From: d_ziolkowski Sent: 23

He's using WSPR. RFI as a cause doesn't make sense. An issue with USB or something with Windoze settings does. 73, Jim K9YC

On 23/04/2021 21:12, d_ziolkowski wrote: Dan, you must click Enable Tx to initiate Band Hopping. 73 Bill G4WJS.

Bill- thanks for that info. But I have NO band hopping at all, SO is this version capable of Band Hopping? It sounds like yes, but mine is not working. See png attached, the space along the bottom