Found the problem. I was starting JTAlert from a .bat file but I had the wrong argument. Everything came up fine but the Band Activity colors were not being changed by JTA. dod

Thanks Bill & John, I think I will try John’s approach first. It sounds simpler. I know how to create another config file. W8KEN - Ken

The Meinburg monitoring service only works with Meinburg NTP so both must be installed and the windows time service (or any other time service like D4) must be disabled.

Tnx Bill....it sure would be nice if it would TUNE (for the RF-sensed auto ATU) on every band hop UNLESS "RX ONLY" was ticked. When using multiband antenna with auto ATU, the TUNE burst would be

More details-- Hamlib error: Protocol error

Hi Ken, you can do that with a minor limitation. Create a symlink (hard link on MS WIndows) so that same log file is visible in both instances log files directory. You will need to

Hi Ken, Instead of 2 instances, you can create 2 "CONFIGS"; one setup for each radio & they will both use the same log file. 73 - John - N7GHZ

Hi Bob, WSJT-X only transmits on bands scheduled for transmit. It does that on the assumption that you may not be licensed to transmit on bands not set to Tx in the schedule. 73 Bill G4WJS.

I have created two instances of WSJT-X, one configured for my K3 and one configured for my IC-7610 Radio. Both instances work. Does anyone know how to point configure both

I found the Meinburg monitoring software refuses to run because “NTP Service not installed”. I tried it with Run As Administrator, same results. It appears we need to install the Meinburg NTP

I use NetTime, also. Very simple and straightforward, lightweight, and works like a charm right out of the gate. Highly recommend. dh

TEST - Please disregaed

Did you update JTAlert after installing the new WSJT program? JTAlert was changed to work with the new version of WSJT. Bill WB6JJJ

When "hopping" in WSPR-2, TUNE (in hopping "Schedule") does not always TX upon band change. Sometimes it does, and sometimes it does not. Desired state would be to have the TUNE function always TX

If the Call 1st check box is clear then the system will wait for you to select a QSO partner. Checking Call 1st will cause the system to respond to the first response to your station that it

Ken, the DDS is phase continuous when doing FSK frequency shifts. The ramping can be disabled in ramped-FSK mode by clearing the TRIANGLE bit if necessary. I did say that any F1/F2 swapping would

Yes, I caught the issue that this chip is designed for two-tone FSK. However, after thinking about your idea, it is not clear that this would work without knowing the undocumented internals of the

Hi Andy, non-linear ramping is well defined for that DDS, the ramp control can be changed and timed on the fly as I said before. Even if the ramp is divided into a few segments with

My interpretation of the datasheet, as below, is that the 9852 can perform non-linear transitions. I think that the more difficult obstacle to overcome with respect to using the auto frequency

Hi Ken, the DDS FSK features are probably designed for 2-FSK where F1 and F2 are fixed, FST4W is 4-FSK so it gets a bit more complex as the next tone shift may be to higher or