Hi Dave I expect that the warning is there to advise folks with a normal ssb filter that the JT4G signal is in danger of being affected by the upper rolloff of the filter, which would attenuate the

I've also noticed - since 2.3.0, that my radio's MIC is hot whenever the radio is in TX mode. That wasn't happening before either.

I ALSO like it! Sometimes I use it to see how much I am overlapping other signals. Just because WSJT-X does decode signals less than 1 Hz apart doesn't mean I shouldn't try to find a clear spin the

I've been trying to receive a weak 23cm beacon over what is always a difficult path unless conditions are slightly better than normal. I set WSJT-X up, monitored for a while, saw what looked like the

Hi Bill and Gregg "looks like the output device is some S/PDIF digital output from a sound card, that is not the SignaLink USB" Not so Bill, the SignaLink has both analog and digital

With Q65 the "Call 1st" setting doesn't seem to work properly yet, you have to double click the station that calls you. As you can see by the way that the boxes TX1 to TX4 are blank. Without those

Hi Bruce 2 channel audio is selected, same as you indicated. Two instances of MSHV run without any problem on L and R. Only WSJT gives issues. 73 Henk -------- Oorspronkelijk bericht -------- Van:

Hi Joe It is not a K3s issue. Other applications using K3 main/sub audio are working fine. It is only WSJT that gives no difference between L and R audio. The other applications do that on the same

Bill WAV file mailed to your private address Tom GM8MJV

Now I can't get it to run past the 1st decode attempt after starting. I'll try running in a different mode 1st and swap over to JT4g. Dave (G0DJA)

OK Bill, I'll set "Save all" to on. Previously was 'Save Decoded" as the empty WAV files end up taking up space. Cheers - Dave (G0DJA)

On 24/02/2021 12:44, David Ackrill wrote: Hi Dave, a saved .WAV file that reproduces this issue would be helpful. Send to g4wjs <at> classdesign <dot> com. 73 Bill

Unfortunately, It's just happened again to me. I had been running JT4g trying to detect signals from a 23cm beacon and it had been running for some time. I just came back into the shack and there was

Setup a vanilla configuration for FT8 and switched to it - radio can set there RX'ing no issues at all. Setup JT4G configuration - switched to it - 2 mins later Sub Process Error appears Repeated and

Sorry Charlie, I deleted my earlier reply as I think I was remembering the original issue before the second release of 2.4.0. Cheers - Dave (G0DJA)

hi Pascal if its the same issue i have on windows, to get wspr to work, start wsjt-x, change mode to wspr, immediately make sure BANDHOP box is unchecked and make sure you are not TX once it has

On 23/02/2021 22:26, Gregg wrote: Gregg, looks like the outoput device is some S/PDIF digital output from a sound card, that is not the SignaLink USB which as far as I know is

Morning Charlie To be honest I can’t remember, the way wsjt-x automatically saves the settings when I start up WSJT-X now it is in JT4 mode. I will reset the mode to ’something’ say FT8 later on

Hi Tom I've successfully used JT4G with 2.4 -rc1 without seeing this error. Which mode were you using prior to switching to JT4? The only subprocess error I have come across is when returning to

I'm going to be the odd man out and jump in here and say I rather like it. Once I got used to it I hardly notice it unless I want to look at it for some reason. 73 -Jim NU0C "Viktor Kadar"