Thanks Rip, the Transmit Audio Source is gray out so I'm not able to change that. I'll play around with the settings and see if anything allows me to change that. 73 de Kell

If I understand how you are currently setup this may explain your problem... CAT controls the frequency/mode control and PTT commands to the radio unless you are attempting to do it via VOX. VOX can

I've quit using 50275 because there are actually OPs that use JT65 in this world. I first found Q65 when I was monitoring 50276 JT65 as VK/ZL use it to work South America during their summer E season.

Bill I am not using it for cat control just the main tx and rx switching of the radio. I had the same set up on a windows 10 laptop which was on its last leg so I decided to move onto the pi but it

David, how are you expecting CAT control to work if you have no connection to the rig's CAT control port? 73 Bill G4WJS.

Bill I am using the 6 pin mini din for the data connection not the cat Din and I am having to use a USB adapter for the pi to connect the 3.5mm. The cat din is connected to my Atu and it does have an

David, I need some clarification, the FT-897 has two mini-DIN sockets, one for audio in/out and one for CAT, does your interface connect to both of those sockets? The Pi 400 has no audio in

Bill I am using the current version 2.3.0

David, which version of WSJT-X are you using? 73 Bill G4WJS.

Hi Bill, The rig is connected using a xggcomms sound card that connects from the 6 pin data plug and then plugs into the pi with a USB and two 3.5mm audio jacks.

David, you have not told us anything about how your rig is connected to you Pi fro CAT control. 73 Bill G4WJS.

Hi Deni, whenever new modes are added you must reset the working frequencies table to pick up any changes, "Settings->Frequencies" then right-click the Working Frequencies table body and select

Hi all hopefully someone can give me tips to go in the right direction. My issue is that I can’t get my radio to communicate with wsjt-x. When I press test cat it just keeps bringing up errors,

I agree, Chris, it's way too early to button down anything. (and we may end up with different freq for intercontinental DX and the typical random qso water holes) What we have done here, as part of

Hello Kell, The only thing I see in your setting is the Transmit Audio Source. I have always set it on Rear/Data. This makes sense because your transmit data is being generated by the computer and

Here is what works fine for me: Jim Bennett Folsom, CA K7TXA (ex W6JHB as of 1/22/2021) Being retired doesn't mean I'm not part of the work force - just that I'm not forced to work!

50.305.... I’ll give that a go Brian Bowers. VR AweldI

I will add to the response "It sounds like more than one program is trying to access the same port", except my suffix will be "for sure" instead of maybe. At least that is my assessment. here is what

Having a problem with 2.3.0.  When I attempt to change from FT4 to FT8 the frequency refuses to change.  Even if I change it manually it does not decode.  Note in the attached photo that FT4 is

I do have that option checked, as I said in the video, I don't remember having this issue in 2.2.2, maybe I was just lucky.. I'll un-check it and see how it goes.. Thanks for the suggestion