Good morning, I must admit, for the very first "shot" of Q65 it works great. Can't wait for improvements... Its" lockdown-time" and what else can you do : This week I ran my "personal testseries"

I recently noticed that while xmitting FT8 on my IC-7300 the entire audio spectrum is occasionally (maybe 5-10% of the time) all combined into what looks like a broadband 2-3KHz spectrum with the

Andy, I changed my call recently from W6JHB to K7TXA. When I log into groups.io and go to my Account, it shows me as w6jhb@..., which, for the time being is the correct and valid email address. If I

In just this message stream it looks like he is posting from two different accounts/subscriptions - no wonder he is getting so many messages! LOL

Hi David You are right this feature is not implemented on the A and B sub-modes which is probably an oversight for a Beta test version. But it does work well on the C, D and E sub-modes that are

Jim your account is still set to "individual messages" Andy K3UK

Last time someone had this issue, it turns out that had subscribed twice with different emails and one account was set yo all messages. I'll take a look under the hood for you. Andy K3UK

Another way to say that , David, is: “…there is no ‘free lunch’…” But, then again, I don’t have a Nobel, the program is free and its winter… I’m willing to give it a try, and

There's been a lot of excitement and expectation that has been created by the release of the Q65 series of modes, in my opinion. There's been chatter about these being "the next new..." enter your

Obviously no one takes the time to read the Q65 Quick Start guide ... https://www.physics.princeton.edu/pulsar/k1jt/Q65_Quick_Start.pdf Neil, KN3ILZ On 2/12/2021 5:47

Yes Bill, I agree, but that's not what many operators who are testing Q65 seem to be expecting... They are, maybe wrongly, assuming that Q65 will somehow replace FT8 or FT4. Much of the testing,

Hi Rex, No, they don't, at least not in some modes of Q65. For example, Q65 30A looks like this with Sh selected...

OK Bill. Thanks. Interesting. Thank youfor the reply. Joe, K1YOW

Hi Dave The spectrum below the waterfall has indicator letters T, M, R and 73 which correspond to the single tones and they move with reference to the frequency you are working such as 600 Hz to

Hi Joe Checking Sh to send single tones such as @1000 Hz = tune, @1250 Hz=Send Messages, @1500 Hz=RRR and @1750 Hz=73 is the expected behaviour. It is used to complete very weak or marginal QSOs

Thanks for the replies and suggestions. I tried all of them but no luck. The frustrating part is that this combination of hardware was working great not that long ago. In between I was using and Icom

I looked and looked but I can't seem to find a RigBlaster forum.. Does anyone know where that one is? Thanks all Dennis N6NG

I have a TS-570S but I am going to guess that a few things are similar so let me throw out an idea. Change the handshake to hardware. My TS-570S uses a hardware handshake and I don't know if this is

Hi Joe, that is expected behaviour. The short code messages in Q65 mode *are* single tones. Single tones are used by some EME operators to complete QSOs with maximum

in windows, 8 , none, 1 and also had to have dtr and rts high, maybe your should also be that way Dave Garber VE3WEJ / VE3IE