I looked and looked but I can't seem to find a RigBlaster forum.. Does anyone know where that one is? Thanks all Dennis N6NG

I have a TS-570S but I am going to guess that a few things are similar so let me throw out an idea. Change the handshake to hardware. My TS-570S uses a hardware handshake and I don't know if this is

Hi Joe, that is expected behaviour. The short code messages in Q65 mode *are* single tones. Single tones are used by some EME operators to complete QSOs with maximum

in windows, 8 , none, 1 and also had to have dtr and rts high, maybe your should also be that way Dave Garber VE3WEJ / VE3IE

it sounds like more than one program trying to access the same port, maybe Dave Garber VE3WEJ / VE3IE

I did a quick test toggling the "Sh" box and the "Tx6" box. I guess that "Sh" stands for 'Shorthand', as in the Shorthand messaging used in other modes? So, clicking on "Sh" changes Tx4 to

On 12/02/2021 21:13, smith.rip@... wrote: Hi Rip, the default baud rate for the USB virtual serial port is 115200, you have 9600 in WSJT-X which is probably wrong. 73

Hello all I just swapped in my Kenwood TS-590sg and attempted to get it up and running with WSJTX. I had had this setup working nicely a few months ago but I put in a different radio for a while. When

Hello, I am using OMNIRIG 1.19 together with SDR console V3.0.26, FT817 with microham USB III interface and it´s virtual coms. All settings OK all function OK for the SAT. Now I want to add

I found out what the issue was, and it isnot configuration change related but it only happens when in Q65. On the IC-9700, I had Sh checked from thelast time I ran MSK144 on 2 meters. So, no

All are present and available to other applications. Chris, AB6QK

That was my suspiscion, But rolling back the update did not change anything. The radio is a Kenwood ts-450s which is properly selected in the settings. There is no special driver for this radio.

Ironically, the only device showing is the Windows Default. No, the device needed is not the Windows default. The device I'm using for the Kenwood is a c-media pci card, which works fine with other

All seems to work well. Just a couple of small things to report so far. I run a TR590SG in one configuration and an IC-9700 in a second configuration. Running V2.4.0-rc1, Windows 10, 64 bit. 1. In

>You did misunderstood the situation when it happens. I am not calling CQ (in search-and-pounds) and I the "Hold-TX-Freq" is not checked. Geza, Many users prefer to follow the recommendation to

It looks like a Q65 mode , someone transmitted it by mistake 73, N0AN Hasan

144.170 MHz seems to be developing as a "standard" here in the Midwest USA.

You did misunderstood the situation when it happens. I am not calling CQ (in search-and-pounds) and I the "Hold-TX-Freq" is not checked.

Thanks for all of the responses. I suppose that I should have known what this was but I did not and now I do. I am going to pay particular interest to the comments from Bill S. because my first order

There was just a Windows 10 update. This happens each and every time MS sends out an update. If you're using a single USB connection for CAT and audio, the answer that I've