>I was focusing on the "....worked before status" piece and didn't make the connection. You are not alone. I had to test first to be sure, hi! 73, Reino OH3mA

Do you have WSJT-X rig setings like these? Also make sure you are using USB-D mode. 'Kari On 5.2.2021 20.44, Chris Mitchell via

I was focusing on the "....worked before status" piece and didn't make the connection. My display is 'back to normal'. Thanks, -Steve, W7WM

Hi Steve, User Guide section 4.1. General tab, tick ”Show DXCC, grid….” 73, Reino OH3mA

Hi Kari Yes, it does. Chris

I have apparently clicked a box somewhere and the Band Activity pane no longer shows the DX country or prefix. Will someone please tell me how to get it back? I believe I have looked at all of the

On 04/02/2021 09:41, Dave Crook wrote: Hi Dave, and Mike, thanks for the issue reports, we are looking into it and it will be fixed for the next release. 73 Bill

Chris, Does web page https://time.is/ report your time as being "exact!" ?? 73's de Kari, oh2gqc

to the team congratulations on the new Q65 mode which I find of real interest for my small station EME activities To Joe and Bill. I tested the new Q65 mode to gain some experience with the sample

Hi, I have just started using WSJT-X. I am unable to see any decodes of FT8 signals. There are plenty on the waterfall and the signals are audible through my rig speaker (IC-705). In the settings/

Thank you to the WSJT-X team for incorporating a "no shaping" option into v2.3.0. It will be greatly appreciated by many FST4 and FST4W users. Reading the release notes, the comment is: FST4/W:

Minor correction (so there is no confusion): pi@myraspberrypi$ sudo dpkg -i install <whatever you want to install> should be: pi@myraspberrypi$ sudo dpkg -i <whatever .deb you want to install>

There is an easier way: pi@myraspberrypi$ sudo dpkg -i install <whatever you want to install> blah blah blah failed because of dependencies... pi@myraspberrypi$ sudo apt-get -f install [messages

Hi, You are missing a load of dependencies needed to install the later versions. The dependencies must be installed first. Try, from the Pi@raspberrypi $ prompt ( not the download prompt

Hello friends After setting up 2.4.0-rc1 - which went fine - I first time used the [Configurations] Tab, where one may save an actual setup. This has its "special" philosophy", but one understood, you

Thanks Reino "single decode" was ticked. cheers Wayne VK4WTN

>hi all, just installed wsjt x v2.4 today and it works well. I am just wondering how to enable multi station decoding. At present I seem to only decode the signal that I have clicked on regards Wayne

>The number of Submodes, together with the number of different seconds of TX/RX, plus the variations of FTol, are making me wonder if I could, actually, count the number of monkeys needed to be in the

This Raspberry Pi 3B+ used to work great with WSJT-X, but now it no longer opens. I can run JS8CALL just fine. I downloaded both 2.3.0 and 2.4.0 RC-1, and neither of them worked. First I upgraded

hi all, just installed wsjt x v2.4 today and it works well. I am just wondering how to enable multi station decoding. At present I seem to only decode the signal that I have clicked on regards Wayne