Hello everyone, I've just joined this group and would be interested to know if anyone can shed some light on an issue I'm experiencing. I do quite a bit of work on 630 m using a TS-890S exciter and a

my steps work, if you find a spot first , then go searching and poucing... Dave Garber VE3WEJ / VE3IE

Hi Markku, On 28.12.2020 14.56, Markku SM5FLM wrote: Unfortunately no, the mouse behaviour is 'hard coded'. I fully agree. Changing tx-frequency is the most used

Agree –but I often wish to move my transmit frequency during a transmission without losing the ham I’m receiving. 73 -- Larry -- W1DYJ

if you right click and let both receive and transmit go together, then when you click on a " qso partner" only receive will move and your transmit will stay, if you have 'hold Tx Freq' selected Dave

I use fake it, so my vfo b can remain whatever I set it to , and does not get changed Dave Garber VE3WEJ / VE3IE

Also agree. 73 -- Larry -- W1DYJ

Hi Jan, we do not provide Doppler shift tracking for non-WSJT-X modes. There's no need to change settings when you wish to switch to another mode, just click the "Monitor" button which relinquishes

Hello, I use WSJT-x with my TS2000x successfully. As soon as I switch to CW, I need to go to settings and change radiosettings to No Radio. Till now it is a satisfied work around, but entering the

I agree this would be very helpful-- Anthony Luscre K8ZT Ohio Section Section Youth Coordinator & Education Outreach ARRL - The National Association For Amateur Radio™ k8zt@... (best for Amateur

On Mon, Dec 28, 2020 at 01:07 AM, Joe Subich, W4TV wrote: 1) there are much better interfaces than Signalink at not much more money.There are some interface devices, eg. the G4ZLP DigiMaster DataLInk,

Hi OM, unless your IC-705 has a serious issue with lack of filtering on the USB connection I would suspect the noise pickup from your PC is via the main station aerial or transmission line. Is this

Is it possible to change mouse configuration? I use shift+right click very often for setting the tx-frequency, but it requires both hands. I rather have this function on the left mouse click. (Which

Hi, I'd try a different USB cable first, perhaps even a usb 2.0 cable, not 3.0. ... try a couple different ones if need be. I have heard a couple of other folks having usb 3.0 noise issues. Hope

Hi. Using a laptop and a ic-705 all in batteries. Using a usb 3.0 cable with 3 ferrites. Version 1.11 usb drivers and had tested with version 2.2. and 2.3 of wsjtx software. Windows 10 with full

Bill, For some time it has not been easy to manually upload spots to WSPRnet. It seems the format of the lines has changed. Mark KB9AMG noted a while ago "I recently had to upload some spots after

I have the same radio (TS590-SG) and I have it set to Rig and have had no problems. On 12/27/20 9:07 PM, Jacques Pecourt wrote:

Thank you for the tip Bob. Does choosing "Rig" take care of which VFO is used or should I do something else? Jacques W2/F2YS

I suggest you use Split set as Rig. Then you won’t have to worry about where you land. The software takes care of it. It uses VFO A for RX and VFO B for TX. Just let the software handle the

After much help from you all in this Group, I finally got my TS590-SG running very well however I noticed strange behaviors on the subject. Following the Kenwood recommended settings I ticked the