Thank you for the tip Bob. Does choosing "Rig" take care of which VFO is used or should I do something else? Jacques W2/F2YS

I suggest you use Split set as Rig. Then you won’t have to worry about where you land. The software takes care of it. It uses VFO A for RX and VFO B for TX. Just let the software handle the

After much help from you all in this Group, I finally got my TS590-SG running very well however I noticed strange behaviors on the subject. Following the Kenwood recommended settings I ticked the

JTAlert is a great add on to WSJT-x. I use it in conjunction with Ham Radio Deluxe (HRD) Yes it cost but not bad for all the features that I use in it. JTAlert uploads to my QRZ log, eQSL and then I

Later models have that resolved. Bob, K4TAX

I had one and the noise floor was very high. There are mods but I’ve never tried it. 73 Ria N2RJ

Bill Use the ACLog export as ADIF function (I am assuming it has one as all ham radio loggers should) - take the logfile and copy it to wsjtx_log.adi (Use File - Open Log Directory to get the correct

Dick One simple check - don’t start JTAlert (no need to remove it just don’t start it) does the problem still happen? You don’t even need to work someone - pop a callsign in WSJT-X and then

Yes I can believe that, looking at some of the ones the system decoded.

I use JTAlert in conjunction with WSJTx. After working a station, WSJTx transfers that station's data into ACLog. All working fine, however on occassion JTAlert will indicate that I have worked a

Greetings All ! I hope your holiday season is going well. I am experiencing problems with my system since addinf JTAlert to my operations. I am using the following setup: -DELL E6510 Laptop running

1) there are much better interfaces than Signalink at not much more money. 2) If one wants to use an inexpensive sound card, it is very easy to build a one resistor, one transistor PTT circuit driven

Maybe for the 756Pro, but for LOTS of radios, the SignaLink represents a simple solution for FT8. Some rigs use CAT to turn on the front microphone which defeats the rear digital mode audio.

I run 20 MILIWATTS ...... .02 Watts on WSPR using a WSPRLITE powered by a USB Charger. I get reports from all over the world.. I need less power or an attenuator to even "see" how my beam's

Are you by chance running any other software or running WSJT-X via another application? I've seen cases where closing an application does not release certain parameters with other

Bill thanks, poor choice of words contact better choice would have been reception report of a beacon I do realize WSPR is one way communication to test propagation which was actually what drew me to

There are good reasons not to use a Signalink. Google. Bob - wd6dod

Hi Martin, the "Pwr" slider is an attenuator, slid to the very top is is 0 dB (full power), which is where you should set it when adjusting settings. Once set up you may use the "Pwr" slider to make

Hi Kelvin, the IC-756 series of rigs have Rx audio and Tx audio connections on the rear ACC socket. It sounds like you already have a CI-V CAT interface of some sort allowing HRD to

Practice sessions and photos! See below. Please feel free to share this with your local club and other appropriate channels. Last year with FT contesting still being such a new thing we scheduled