Charlie, if your screen captures are supposed to represent the settings you used along with the rig menu settings above then it's no surprise it doesn't work. You have set the CAT

Hi Charlie. Did you try MODE data/pkt on WSJT-X? 73. Carl - WC4H

You show microham set to 38400 But radio's dump says 4800

Did you set the jumpers inside the microHAM device for an RS-232 connection (page 5 of the USB Interface III Users Manual)? 73, ... Joe, W4TV

Still getting RED on the set-up button Loaded current version WSIT- v2.2.2 and using MicroHam USB Interface III for COM Ports. I have the CAT and RTTY/PKT cables connected. RTTY works OK. I receive

Hamlib error protocol error while getting current vfo frequency

You would do better to ask this on the JT-Alert groups.io support list: hamapps.groups.io That said, do you have JT-Alert setup to access your local logging program? Did you run the

I've read the "help' stuff but have not found out HOW one enters a specific GridSquare into the Settings ===> Wanted Grids window. In that window there is a BIG empty square that does not respond

Am I stupid or not? Forgot to switch back after CW operation, oh my... Tks for help. Wolf Wolf KnipferSkipper + SegellehrerOsterweg 45D-25821 Struckumfon +49 4671 94372-13fax

Wolf, No problem! You have receiver filter set to about 500 Hz and 800 Hz bandwidths depending on band. 500 Hz at 10m and 800 Hz at 20m bands. 73, Reino OH3mA

Angelo WB9RWL, 60M is a great Band for FT8. It's never crowded and I've even dropped the power down to 5w and made QSOs to EU with an end-fed longwire. 73, Bob K8BL

I'm running WSJT-X 2.2.2 with Windows 10 pro and a Yaesu FTDX1200 via Yaesu SCU17. Suddenly I am getting a very strange waterfall on almost all bands. I have the strange feeling that I there is

I’m not sure FT8 will, but JT65 worked quite well with two on the same frequency - not even one Hz apart. For 20 and 40, jump on FT4 and try it. On very busy days, you’ll also find FT4 on 17m

Hi Jean-Michel, This discussion has assumed that operators use ‘Hold Tx Freq’ selection and have chosen a ‘free’ transmit frequency for their potential transmissions including answering

I often get calls while I let the program in monitor and am not actively operating, Being in Delaware JTAlert sounds its alarm and I will answer the call. Nice to help others get DE confirmed. 73

Hi, In case anyone needs it, here is a screen shot of the FTdx10 settings on the software side using the 101D profile. I got the radio last evening and have been making Q's all morning long. --

So John, you beat me to the pun. And far better than I would have done. 73 Phil GM3ZZA Sent from Mail for Windows 10

Hi Jerry, if it is definitely the right serial port then make sure no other application has it open. If you are on Linux then make sure your user is in the dialout group. 73 Bill G4WJS.

Can someone advise possible reasons for the following: "hamlib error: IO error while connecting to rig". I believe all the settings are correct and the right com port is selected.

I thought it was only me. I've had that happen with other calls but figured it was just something I did. I've also had stations call me and when I reply it jumps to RR73 and will not allow even a