Hi, The attached image shows what happens: I (DG5LP) called NJ4P with my serial-nr. 173, but he returned to KE8ZNL. Then I called TA7YOG using the same serial-Nr. 173 and could compete the QSO. Thus

Valid question. I did yes.. uninstalled then deleted the directories, re-installed.. brand new.. had to put in my call sign, change fonts... Same problem.

The last time I had to fix an audio problem I had to dive deep into the windows 10 system files. This was after an update and I did have to load drivers. Silly question, but did you do a complete

Same FT4 "computer crash" problem here using 2.2.2 ..... didn't hear about 2.3.1 correcting the issue until the contest was over! 73, Dick- K9OM

Have you turned off all Power Saving for USB hubs? You'll have to do that in the Device Manager by selecting each USB hub, finding the Power tab (if it has one) and uncheck the 'allow

I also ran across this problem, and it was in fact caused by missing/incorrect EXCHANGE info. from the other station. WSJT-X crashed on my five times while in FT4 mode, though, as it did for a number

The error message shown in the attached file started popping up about four weeks ago. When that happens FT8 stops decoding and CAT control is lost. It happens at random times and I can't find any

Thanks Bill , I installed the 32 and 64 bit open SSL . I also downloaded my complete log from LoTW , most likely to much info for WSJT . I did install that file into Open Log Directory with no luck

On Mon, Dec 7, 2020 at 05:40 AM, Bill Somerville wrote: I agree it is a little confusing and I have changed it to say "... typing this line ..."Thanks so much, Bill, for your attention to even these

Had this happen a several occasions and found the exchange was incomplete either sent or received, usually received. The first time this happened I did not catch the incomplete exchange and had to

Hi Peter, WSJT-X supports transverters, particularly if you IF rig has working CAT control. Set the offset field in the "Settings->Frequencies->Station  Info" table for the target band. The offset

i am looking at getting one or two transvertors from the ukrainian guy to extend my HF rig up to 2mtr, and possibly 4m and 6m are there any options in WSJT-x to cope with using transvertors or would

Thanks...was hoping the .ini "solution" was just that...but alas, it seems not. John

Thank you Bill. Its appreciated. Derek - J35X On 12/7/2020 7:52 AM, Bill Somerville wrote: Virus-free. www.avg.com

If I had the time to study sure.. but I don't. Any study time I have needs to be on CW or work (nearly 70,000 Windows devices)..

Hi, Neil Thanks for the insight. I thought I had it checked, but now I’m sure I didn’t. I downloaded 2.3.0-rc2 and now make sure Call 1st is checked. Out of a dozen QSOs this morning, there

I got tired of constantly waiting for Windows 10 to start, and update, and fixing issues after updating. I bit the bullet and switched to Linux, in my case a Raspberry PI. There's a learning curve to

Hi Chuck, I also found that happening several times to me during the contest, but on closer examination, I found that the station I worked had not sent all the proper info for the exchange and I

I gave up on the FT8 Roundup yesterday after the eighth crash as described above using FT4. It seemed as if the program always crashed when I had just gotten a response from a new multiplier. For a

Hi Derek, see the FAQ item 2 in the WSJT-X User Guide: https://physics.princeton.edu/pulsar/K1JT/wsjtx-doc/wsjtx-main-2.2.2.html#FAQ 73 Bill G4WJS.