Bill / Joe Yes, I didn't factor in the useful resolution.  I read a couple of reports that agree with your 18 bit figure so 12 dB at best. And I take your point about the RX dynamic range not

Hi Walter, we miss it too ;) I can confirm this is a known regression defect in WSJT-X v2.3.0 RC2, it is fixed for the next release. Thanks for the issue report. 73 Bill G4WJS.

Hello All, I miss the date and time in all.txt since version 2.3.0 RC2 this is very bad when I want to search for callsign and date / time... you will find only the callsign... when i TX, then i can

Except for SignaLink and some other PCM29xx based sound cards that have serious internal noise floor issues (previously well documented), the ca. 65 dB net dynamic range of the PCM29xx is more than

On 18/11/2020 14:23, Rick Chapman wrote: Hi Rick, I believe that roughly 18-bits of useful resolution is possible from a 24-bit ADC used in a typical sound card, so the

Bill That's a nice clear explanation. The obvious follow-on question then...   Given that 16 bit ADC sound cards are old technology now, is there any advantage to using a 24 bit ADC sound card?

Hi Greg, I think you will hit another issue with the required Boost C++ library version. This may not be so easy to fix. Again I need to investigate why we set Boost v1.63 as the minimum version,

Thanks Bill, That’s starting to make sense. Especially on reading it through several times. It’s the noise floor, that you set 30 dB above the quantization error, so the contribution that

Hi Bill, I see what you have done and will use the modified wsjtx.patch file in a new build and report back. Thanks, Greg

On 18/11/2020 08:47, Philip Rose via groups.io wrote: Hi Phil, if a decoder requires input signals to be of greater amplitude than is necessary then the gap between the

Joe Subich wrote: > > I find I need to adjust my IC-7300 RF amp differently for wsjtx as > fldigi. Wsjtx has 30dB at the 9 o'clock position. Fldigi goes out of > the green at 12 o'clock. The

Hi Erik, Yes, I have also seen that and pointed it out here. But it hasn't raised much interest. 73, Ingemar, SM0ECF Den onsdag 18

When a ft8 station is calling me with a report in the first call, the wsjt-x will almost always log a previously received (from another station) report. This bug has been in several of the recent

Hi Greg, because of the way we provide a combined Hamlib and WSJT-X build in out sources package you have to generate a patch file if you want to modify the sources of either of those packages. The

Hi Bill, I think this is the relevant CMakeFile.txt from the wsjtx tarball. But I am confused that it gives a minimum version way below mine...is there another CMakeLists.txt file I should

Have edited CMakeLists.txt in ../src/wsjtx dir, but it's still finding a 3.9 clause so perhaps I should edit other instances of this file... -- extracting... [tar xfz] -- extracting... [analysis] --

Hi Bill Have made the following edit to ../src/wsjtx/CMakeLists.txt: cmake_minimum_required (VERSION 3.7.2 FATAL_ERROR) There are other CMakeLists.txt files in different dirs, but have only edited the

My friend is new to digital and just picked up a Xiegu G90 transceiver. I have agreed to help him set it up for WSJTX. To avoid reinventing the wheel I would appreciate getting any information

Thanks Bill ok will do.

Hi Greg, I don't recall why we upped the required CMake version. Can you try editing the CMakeLists.txt file to set the minimum required CMake version to the one you have and report back any errors