As do I. However, there is much information to be had by keeping a close ear to the frequency on receive. Just run it at a very low level. Same for transmit audio if your rig has the capability.

Gary, You would be right, IF I ran wsjtx with the audio up - I don't! I having hearing loss & tinnitus, so sitting there listening to that thing squeal just gives me a headache, so I turn down the

Belay my last. It went for about eight hours with sleep and screensaver disabled. Locked up again. Back to the drawing board. Steve, N4JQQ

I’m not sure how you missed it! You should have been able to hear the fact that you were on the wrong filter, if nothing else. The waterfall would have shown it also, as you finally

Hi Rich and John, that is partially right. For connected devices like serial ports the power save options are not in play as having a connection open is enough to stop power

Hi Rich, The kb & mouse activity is true, but since you need to move & click the mouse to log, & select new stations to operate... the system still isn't picking that up. 73 - John - N7GHZ

I'm big enough to admit when I do dumb stuff... So early this morning, I worked a bunch of FT4 & FT8 & everything worked fine. I then did some experimenting for about half an hour, & after that I went

Windows makes its decisions on power-saving actions like sleep mode based on keyboard and mouse activity. It does not know about activity on serial ports, sound cards, etc. There are settings that can

Thanks, Reino, you nailed it – all is OK now. 73, Chuck

Ya know, After reading hundreds of these types of issues during the past 6+ months, it really make one wonder what the real problem is...! Ask yourselves, why in the hell are these computers going to

On 28/10/2020 21:51, w1pr@... wrote: Hi Paul, if you want to start WSJT-X from a CMD shell you can do so like this: C:\WSJT\wsjtx\bin\wsjtx --rig-name=my-rig that

I'm probably overlooking the obvious but I don't understand how to enter the separate radio commands. When I try to use the command from a command line, i.e., C:\> I get the following: 'wsjtx' is not

Russ, there is a known defect in WSJT-X where the Band Activity window stops scrolling down to show them latest decodes, the defect only occurs when

Hi Bill, Thanks for the response. Yeah, that’s what I was saying in my post. Yet WSJT-X was frozen when I collected them. This thread is asking why that’s happening. You asked its originator to

Thanks much Bill, This never happened until I upgraded to 2.2.2. This feature is a hassle for me since I use two different radios. Dave KC3AM On 10/28/2020 13:46, Bill

Thanks to all who responded to this cry for help. It only took me a little over a week to figure out that it apparently, I hope, was the sleep mode on my new Windows 10 machine. I didn't know there

I was just about to follow up on a post I made earlier, actually several. My receive was locking up after a period of time with new Windows 10 computer. I'm not an IT guy so I was confounded. I

On Freitag, 16. Oktober 2020 07:53:38 CET you wrote: Moin, thanks for all the answers. > A lot of people use loggers that get the locator data from e.g. qrz.com. > Might I suggest making a

No Trend. Same-ole-same-ole ..actually rebooted twice today ...numbers are quite typical of what I have been seeing. -- -- Bob KD7YZ in NE Kentucky

Hi Bob, is there any trend of DT numbers getting larger, if yes do they reset after a reboot? 73 Bill G4WJS.