You mention "ground bus". I assume that means you have things grounded in different places along that bus. Try putting one bolt through the bus and run 1 ground wire from each to that bolt....a

After much experimentation. It appears that I do have RF coming into the Shack. Even with the Linear Out of the equation set, 50 watts is enough to knock out WSJTX. I have heavy gauge wire welded to

FYI, reducing the baud rate to 9600 hasn't made any difference. About 20% of the time the Halt TX button turns off the Enable TX button and causes my rig to beep with the expected .. _ , but

I do know I have RF coming into the shack. I have ferrite beads on the USB cable. The antenna is up at 75 feet off the ground (G5RV) tuned well. I have heavy gauge wire from my ground bus bar to the

If you've got a dummy load try using that. Frequently this turns out to be RF in the shack. USB cables, ethernet cables too can be culprits. I worked with someone last week and had him move his USB

I have had some similar problems and it turned out to be RF getting into USB cables. Transmitting lower power helped but I got some clip-on RF beads and put them on the USB cables and it took

I Have an ICOM-7300 connected to a HP Laptop Quad Core running Windows 10 64bit Professional. I have been getting intermittent Audio Input errors on WSJTX 1.7 to 1.8 ever since getting into the JT65

Hi all, I Have an ICOM-7300 connected to a HP Laptop Quad Core running Windows 10 64bit Professional. I have been getting intermittent Audio Input errors on WSJTX 1.7 to 1.8 ever since getting into

Good thought but it's already Disabled. This ONLY happens on WSJT-X ... never on DM780. Dick

Your USB is going to sleep. Under Power Options, Advanced settings. disable USB selective suspend. de Mike W9MDB On Tuesday,

I use a SignaLink USB so I have the Output set to Speaker (2-USB Audio CODEC) but periodically when I start WSJT-X it comes up outputting to the computer's speakers even though the setting still says

This bug was apparently not fixed in WSJT-X v1.8.0. Yesterday I had this QSO with KD5FOY: 191345 -19 0.1 596 ~ CQ KD5FOY EM12 171119_191400 Transmitting 21.074 MHz FT8: KD5FOY

Thanks to all who replied. I guess I ham-fisted a checkmark into the Contest block. All is well now.

Hi you might have hit the button in Preferences, Advanced that put the software in contest mode see which will make what you describe happen 73 robert W6INO W6INO ~~~~~~~~~~~~~~~~~~~~~~~~~~~ Twenty

On Sat, Nov 18, 2017 at 04:52 pm, tom wrote: Gary, I have exactly the same rig and station setup software versions that you do. The only time Halt TX doesn’t work is if I try to halt at the same

On Sat, Nov 18, 2017 at 04:51 pm, Dave Garber wrote: Why are you not using the internal sub codec and db9 direct. Maybe there is a buffer delay between your radio. And software going via the vspe

On Sat, Nov 18, 2017 at 11:33 am, Michael Black wrote: There's a difference. Clicking Enable to disable while transmitting continues transmitting....indicating you don't want to transmit next cycle.

its working now but here is the screen shot

Hi Randy, can you right click the wsjtx.exe application and select "Properties" then the "Compatibility" tab and send me a screen capture of the settings please?

I am using Microsoft Pro 10. I found a work around by using "trouble shoot compatibility", When you select "test program" it will open. Am I the only one who has a problem? Virus-free.