Doug, those instructions apply to any and all of the numerous ways of delivering Tx audio to you rig. The controls may look a little different on the latest Windows 10 systems but they are

On 13/07/2020 18:50, psimon@... wrote: Hi Paul, what rig are you using and how is it connected for CAT control? 73 Bill G4WJS.

I have been trying to use band hopping between 20M and 30M to compare propagation changes. Retain power and tune power are both checked. I have two problems; after a while tune power reverts to a

Hi Bill, I have a modern pc, and use usb. No signal link here or old windows. So this control does not show up, or apply. any other suggestions ? Thanks for your help (already) Doug AE0DC

V2.2.0 or later... that is... 73 - John - N7GHZ

If you have upgraded wsjt-x to v 2.2.0 that is normal operation & all is well. It has 3 decode cycles If you read the release notes it gives the details there. 73 - John - N7GHZ

The adif file error doesn’t happen if you upgrade to the new version over the old version, thus keeping your original adif file. This is how I normally upgrade so that I keep my log and

I am running a Raspberry Pi 3, the rig is a FT-817ND. I changed wsjtx rig to the FT-857 and now I have WSJT-X working. TNX. Sent from Mail for Windows 10

Why? The one is easily fixed with any text editor, and the other is really only affecting certain rigs. Neil, KN3ILZ On 7/13/2020 6:38 AM, Tommy via groups.io

Dan, I'm new here. I would like to ask you about the settings you used within WSJT-X. I have a USB Signalink and an IC-706MKIIG. I can not seem to find or set the proper settings for the radio.

I just upgraded my system to a Ryzen 7 3700x from an i5-7600T. The decodes now quickly happen almost 2 seconds before the timing slot ends even if set to Deep. But at the very end of the time slot all

Well spoken Loren. If you have a ”work around” to solve the actual problem you can use this solution temporally . We remember many programs Is free to use, made by enthusiasts who use a lot of

Hello. While trying to install latest 2.2 version with gdebi i receive (before installation) error with some dependencies. Please find attached txt file with lintian output of gdebi . I hope it will

Hi Personally After upgrading i would wait till the errors Hamlib And ADIF export log headers are fixed) . Best Regards Tom

Hi Edward I Fixed the WSJT-X ADIF Export<eh> error ...Open log file and add a o between the e and h so it reads WSJT-X ADIF Export<eoh> save problem fixed happy days ..73 Best Regards Tom M0HYE

Never used FT-857 instead of FT-897. This is the first time with the new 2.2.2 version it did not function. I cannot answer for other versions of transceivers. OZ4GD / Per Fra:

I usually let a week or two go by as sometime fixes are still sometimes in the works before I upgrade.

Hi Jay, what version of Windows are you using Jay? 73 Bill G4WJS.

Hi Bill - tnx for reply. didnt work. Then un-installed WSJT-X, downloaded it again, same problem. Any other ideas ? -- jay ny2ny

Hi Ken, I'm not sure anyone should be running Windows 8.0 any more, 8.1 was a free upgrade that fixed many issues. I have been running every version of JTAlert