Hi Mike, if the Hamlib problem is that the FT-817, FT-818, FT897 rig models do not work, then use the FT-857 model. Do you have any more details on the WSPR reporting not working please? The sources

OK, probably not ;) 73 all LA5VA Steinar -- Steinar LA5VNA

The WSPR reporting on the tar complied version on Ubuntu 20.04 does not work, along with the hamlib problem. Guess I'll pull it all apart and go back to the packaged .deb previous version. Mike VK8MA

Nice bit of rhetoric there guys & gals, but the big one is the hamlib fix. After going thru all the pain of building from the source file, my WSPR site will be doing Rx only of 20 M as I can't talk to

Bob Thanks from me for a very clear exposition of the question you wanted answering - it happens increasingly rarely now, particularly if you frequent Facebook groups. For me, the best analogy is to

Hi Bob, You are 100% correct in everything. Also, you explained the question and assumptions in basic terms, which I love. Another factor we must consider it the clock difference DT (difference in

I dunno, other than FT8 has been around much longer than FT4. Some folks just got FT4 working correctly with their log books, and electronic QSL services in the past couple of months. _________

Naïve as I am, but when operating in the HF bands there are two notable differences between FT4 and FT8. 1) FT8 has a handful of dB theoretical lower noise floor advantage over FT4, and 2) FT4 has

It's an ICOM 7300 with CAT. With ubuntu and windows.

Doug, those instructions apply to any and all of the numerous ways of delivering Tx audio to you rig. The controls may look a little different on the latest Windows 10 systems but they are

On 13/07/2020 18:50, psimon@... wrote: Hi Paul, what rig are you using and how is it connected for CAT control? 73 Bill G4WJS.

I have been trying to use band hopping between 20M and 30M to compare propagation changes. Retain power and tune power are both checked. I have two problems; after a while tune power reverts to a

Hi Bill, I have a modern pc, and use usb. No signal link here or old windows. So this control does not show up, or apply. any other suggestions ? Thanks for your help (already) Doug AE0DC

V2.2.0 or later... that is... 73 - John - N7GHZ

If you have upgraded wsjt-x to v 2.2.0 that is normal operation & all is well. It has 3 decode cycles If you read the release notes it gives the details there. 73 - John - N7GHZ

The adif file error doesn’t happen if you upgrade to the new version over the old version, thus keeping your original adif file. This is how I normally upgrade so that I keep my log and

I am running a Raspberry Pi 3, the rig is a FT-817ND. I changed wsjtx rig to the FT-857 and now I have WSJT-X working. TNX. Sent from Mail for Windows 10

Why? The one is easily fixed with any text editor, and the other is really only affecting certain rigs. Neil, KN3ILZ On 7/13/2020 6:38 AM, Tommy via groups.io

Dan, I'm new here. I would like to ask you about the settings you used within WSJT-X. I have a USB Signalink and an IC-706MKIIG. I can not seem to find or set the proper settings for the radio.

I just upgraded my system to a Ryzen 7 3700x from an i5-7600T. The decodes now quickly happen almost 2 seconds before the timing slot ends even if set to Deep. But at the very end of the time slot all