Hi Don, the problem seems to revolve around anything that could carry audio and supports hot-plugging. that boils down to USB and things that carry USB connections. Setting all USB hubs to not be

Michael, VSPE COM port splitter is a dumb splitter, as in it makes no attempt whatsoever to arbitrate traffic. The RS-232 serial protocol is a one-to-one protocol, it is

Actually, I have multiple applications utilizing CAT control all the time. It works fine, except for WSJT-X. I run fldigi, N3FJP, and MS-DMT simultaneously using VSPE to set up a port splitter. All

Tony, Thanks for your comments. I don't work many JA's with 30W and a LW, so your info is news to me. I do see it a lot from EU's. I have my WD Timer set for 10 minutes since I sometimes walk away

Michael, you cannot have two applications directly using the same rig for CAT control. If the N3FJP FD logging application does not support one of the rig server programs

If all I was doing is running FT8, this would be fine. However, most of the time I will be running phone, with WSJT-X and fldigi not running and doing all my logging directly through N3FJP. I want to

Jim, I do work them. But since I want their Grid in the WSJT Log so it will tell me if I still need that Grid or not I have to look them up in QRZ for their Grid. Then, I have to enter it before I log

Found it--thanks!

Yes .. Hamlib is built into the WSJT-X executable. Try starting WSJT-X, JT-Alert, then N3FJP. I suggest that the reason you're getting the error is that N3FJP is setup to control the

Bengt, the band was open earlier at 1221 according to your log, look at your all text back at that time. Is it possible that you heard AB4IQ back then and called him without a reply then went on to

To answer Roger's initial question - I've only experienced this with stations "in demand". I call them with Tx1 but somehow get Tx3 back so I log a QSO without me ever sending my report. I guess they

Additionally, if I go to configurations, all settings are correct, when I hit TEST CAT, the rig changes to 28.335.19 and a box pops up saying "Rig Failure Hamlib error:Command rejected by the rig

Bob, I am in agreement with you on this. I hate it when I get called by someone without using a grid; so if the QSO is completed I have no idea what grid I just worked, unless I manually go to QRZ to

Getting ready for Field Day. I have the latest versions of WSJT-X (2.2.1), JTAlert (2.16.8), and N3FJP Field Day Log (6.3). My understanding is to start N3FJP > WSJT-X > JTAlert in that order. I have

Fried, I do the same thing just click Enable TX near the end of your last transmission and it will either call CQ or repeat RR73, whichever is required! Any further automation is a slippery slope to

File, Settings, Advanced. Check special operating activity, then put 1D NTX, STX, or WTX. Since you are more North than South or West I would say NTX. It Goes in the FD EXCH Box. So you would say

Make sure you additionally check Special Operating Activity in upper-left corner. Contest, Cope Exuberantly, Hank, W6SX

Hi Charles< go to Advanced in the preferences> here’s mine for FD robert W6INO W6INO ~~~~~~~~~~~~~~~~~~~~~~~~~~~ Twenty years from now, you will be more disappointed by the things you didn't do

From: VE3KTN Date: Sun, 21 Jun 2020 09:21:10 PDT ... It's too bad the logic is set up to detect the

What box do you put them in?