Locked Re: 2.6.0-rc3 UI in JT9 mode #IssueReport
|
Just noticed on when on JT9 the band window below the CQ only box is flashing...20M -78000I was on 20m and same problem happening on other bands.All OK on other modes with no flashing Restarts is not solving the problem.
toggle quoted message
Show quoted text
Just reverted back to Beta RC2 with the same problem on my Yaesu FT2000Seems the problem might been there before on the previous beta??Now on V2.5.4 and all seems to be fine.ON BETA:The radio did go in a stuck TX mode when I clicked enable and cat went to orange with the band window still flashing I had to close WSJTX and DXlabs turn off radio .I hope this makes sense. Shame as would you believe Jt9 is contest busy. On Saturday, 27 August 2022 at 18:08:59 BST, Jim Shorney <jimnu0c@...> wrote:
I'm working the JT9 Activity Days event this weekend and finding that I have some UI problems in JT9 mode only. All other modes in the upper FST4 through Q65 seem to behave normally. Kubuntu Linux 18.04, up to date WSJT-X 2.6.0-rc3 compiled from the source tarball Not using any kind of rig The most obvious things are upon initial startup the frequency defaults to 144.120 and the Monitor button will not toggle off. Stop will not turn off Monitor either. All other buttons seem to work normally. Logging works normally. In the Standard Messages area I can not type anything into TX5 or any of the other message boxen, nor can I select any saved macros for TX5. What is there stays there and refuses to leave. When I first noticed this I also had problems in the Settings tabs. None of the selection buttons nor the OK/Cancel buttons would work. I had to get out by closing the window. That seems to have resolved itself but I do not know why. Computer has been rebooted, checked for new software updates, and did a fresh compile of -rc3 and the problems persist. Version 2.5.4 works normally. I can still operate and make contacts so I would not call this a high priority issue. 73 -Jim NU0C |
|
|