Tim, I haven't set the radio in split mode. For a test I tried setting it to split and made sure both VFO's were set to the same frequency. WSJT-X still decoded and in fact would decode even as I switched back and forth between VFO's. Alas, TX still failed in that config.
toggle quoted message
Show quoted text
At this point I'm led to believe that either I'm not sending ft8 or if I am it's something like a USB/LSB or frequency issue. I'll see if Mike Black sees anything or not. Maybe I'm stuck using the older laptop for WSJT-X.
On 6/21/22 13:42, Tim Dawson wrote:
Unless I am mixing messages in my head, the Hamlib error looked like you were using split? If so, is the *second* VFO also set for USB? If not, you may be transmitting LSB, or ??? which will not be heard. As a test (and if you are running split), try setting split to "None" and retest . . . that way, if you are decoding, you know that the mode is set correctly, and can work the issue from there.
On June 21, 2022 12:33:49 PM CDT, William Smith<w_smith@...> wrote:
Hmm, lots of info here, not sure how much I can help, but a few observations:
On Jun 21, 2022, at 12:08 PM, Mike Ward<woooe48mmex991@...> wrote:Sounds like it, so (and if your ALC is set as below, it sounds like you are doing the right thing there.
On 6/19/22 04:55, William Smith wrote:
On Jun 18, 2022, at 3:26 PM, Mike Ward<woooe48mmex991@...> wrote:So your "RF indicator" shows you are putting out power? How much, compared to the rating of your rig?
WSJT-X (running on Linux) running with my KX3 receives and decodes FT8 fine but no transmissions ever show up on PSKREPORTER. WSJT-X can change bands and follows the frequency if I manually change it. When transmitting I see my radio's TX light come on and the RF indicator shows that it's transmitting.
I have set my Elecraft KX3 to output 10 watts. The SWR shown on the radio is about 1.1 - 1
and the RF indicator shows 10 so I believe I'm transmitting the 10 watts on 14.074 MHz
Unless your small SW transistor radi is receiving USB at exactly 14.074 MHz, you may not hear anything, so I suspect that's a red herring.
I held a small SW transistor radio tuned for it's 19M band next to coax feeding the antenna and I
hear static until tWSJT-X transmits and then I hear complete silence.
I'd upgrade hamlib as per Mike W9MDB's instructions and see if that helps.
I don't know if Linux is as helpful as Windows by adding equalization and echo cancellation, but you should be able to determine if that's the case.
I don't have an equalizer app installed on the new laptop but I could install one just to confirm that the audio is flat.
Wait, what's flucuating? Everything should be constant output, constant power, single tone from the 8 available, etc. If you can hear it, it's a distrinctive warble, look online for sample sounds.
When WSJT-X transmits I see the output device volume control fluctuate so I think sound out is set correctly.
73, Willie N1JBJ