locked Re: Test CAT - Button stays white, no error messages #Cat_RigControl


Mike Ward
 

Willie, N1JBJ

To my knowledge Linux Mint does not inject any eq, echo, etc in the standard install and I haven't installed anything like that.  I was dead wrong when I said the software volume display fluctuates during the tx phase.  It's solid and doesn't not fluctuate throughout the entire transmission.  I updated hamlib, it still failed, and I sent  the rig control log from that failing session to Mike Black.

I really do appreciate your thoughts on my conundrum.

Mike, KE0KAC

On 6/21/22 12:33, William Smith wrote:
Hmm, lots of info here, not sure how much I can help, but a few observations:

On Jun 21, 2022, at 12:08 PM, Mike Ward<woooe48mmex991@...> wrote:

On 6/19/22 04:55, William Smith wrote:
On Jun 18, 2022, at 3:26 PM, Mike Ward<woooe48mmex991@...> wrote:

WSJT-X (running on Linux) running with my KX3 receives and decodes FT8 fine but no transmissions ever show up on PSKREPORTER. WSJT-X can change bands and follows the frequency if I manually change it. When transmitting I see my radio's TX light come on and the RF indicator shows that it's transmitting.
So your "RF indicator" shows you are putting out power? How much, compared to the rating of your rig?
I have set my Elecraft KX3 to output 10 watts. The SWR shown on the radio is about 1.1 - 1
and the RF indicator shows 10 so I believe I'm transmitting the 10 watts on 14.074 MHz
Sounds like it, so (and if your ALC is set as below, it sounds like you are doing the right thing there.

I held a small SW transistor radio tuned for it's 19M band next to coax feeding the antenna and I
hear static until tWSJT-X transmits and then I hear complete silence.
Unless your small SW transistor radi is receiving USB at exactly 14.074 MHz, you may not hear anything, so I suspect that's a red herring.

I'd upgrade hamlib as per Mike W9MDB's instructions and see if that helps.

I don't have an equalizer app installed on the new laptop but I could install one just to confirm that the audio is flat.
I don't know if Linux is as helpful as Windows by adding equalization and echo cancellation, but you should be able to determine if that's the case.

When WSJT-X transmits I see the output device volume control fluctuate so I think sound out is set correctly.
Wait, what's flucuating? Everything should be constant output, constant power, single tone from the 8 available, etc. If you can hear it, it's a distrinctive warble, look online for sample sounds.

73, Willie N1JBJ




Join main@WSJTX.groups.io to automatically receive all group messages.