1. Messages
  2. TS-590SG control

locked Re: TS-590SG control #Cat_RigControl #Kenwood

Gilbert Baron
 

Both CAT and WSJTX can be done through the USB port. The DB9 is not needed. I have a TS590-SG and do not use DB9 at all.

 

Outlook Laptop Gil W0MN

Hierro candente, batir de repente

44.08226N 92.51265W EN34rb

 

From: main@WSJTX.groups.io <main@WSJTX.groups.io> On Behalf Of Dave Garber
Sent: Thursday, September 23, 2021 06:40
To: WSJT-x group <main@wsjtx.groups.io>
Subject: Re: [WSJTX] TS-590SG control #Cat_RigControl #Kenwood

 

why do you need arcp software running, while doing digital??

 

I use the db9 for cat, and the usb port for wsjtx.  i do not run the arcp software unless I do cw ( rarely) or need some changes in the radio ( rarely)

 

Dave Garber

VE3WEJ / VE3IE

 

 

On Wed, Sep 22, 2021 at 3:24 PM KA5VZG <ka5vzg@...> wrote:

I have the Kenwood virtual com port , SDRuno, OmniRig, and ARCP-590G loaded. I can get two to work at the same time. I can have SDRuno running on one monitor and have fldigi controlling the rig on the other. If SDRuno is controlling the rig, fldigi or WSJT-X wont.  I am assuming that the virtual com port will only permit two things to share the port at a time.

When running WSJT-X, sometimes when I click on the dropdown to change frequencies I get an orange display where the frequency normally is displayed (see picture)


at this point, sometimes clicking on the frequency dropdown will open it up again, but it usually will not permit changing the frequency on the rig.
Before this it functioned OK, i.e. can activate the xmtr with the TUNE, and adjust power with the slider.      Anyone else seen this?  Fix?




--

W0MN EN34rb 44.08226 N 92.51265 W

Hierro candente, batir de repente

HP Laptop
Join main@WSJTX.groups.io to automatically receive all group messages.