toggle quoted messageShow quoted text
I took a look at the K0PIR website, he’s great with configuration stuff fot icom radio’s.
Hope this helps.
73 Richard PA3GCU.
Verstuurd vanaf mijn iPhone
Op 13 jun. 2020 om 01:30 heeft Lawrence Dobranski <ldobranski@...> het volgende geschreven:
My IC-7610 is working great with the latest release of WSJT-X.
I have attached my screen shot of the WSJT-X settings.
The configuration of the radio is as follows:
Connectors->MOD Input->USB Mod Level->20%
Connectors->MOD Input->DATA2 MOD->USB
The mode selected on the front panel is USB-D2.
I hope that this helps.
73 de VA3IQ
Do you have the radio mode in USB-D1 mode ? It will receive fine in SSB USB setting, but needs to be in Data USB D1 mode or D2 or D3, depending how its set ? If you have, make sure you PC is generating the tones and does the action of WSJT-X going to transmit, in either normal FT8 sequence or in the Tune position action the radio to change over to TX ? Check what Bill has put above.
The screen shot is pretty poor quality cannot really make much out.
73 Derek G8ECI
On Friday, 12 June 2020, 23:33:12 BST, Bill Somerville <g4wjs@...
On 12/06/2020 14:41, Tad Danley wrote:
Have WSJT-X working on RX but cannot get TX
working. TX config screen shot attached.
I had previously set up the IC-7610 to work
with N1MM+ and a single USB cable for logging, CW, FSK RTTY and
recoded voice messages in N1MM+ - so not sure if I need to
change something in the radio settings, WSJT or both?
Thanks in advance for the help!
Tad Danley, K3TD
you don't tell us what is not happening when you transmit.
I suspect you need to check "Settings->Radio->PTT
Method->CAT", and "Settings->Radio->Mode-Data/PKT" for a
start. There may also be some rig menu settings to adjust, your
rig's manual has details.
This old post should help with Tx audio level settings as well: